Automatic Battery Charger

Product Details:

Additional Information:

• Pay Mode Terms: T/T (Bank Transfer),Other

Product Details:

Input Voltage170-270vacOutput voltage:
Float Mode:26.2 V DC.Boost mode:27.4 to 28 V DCInrush Current:Limited by NTC thermisterCharging current in boost mode:10 ampsCharging current in float mode:0 to 3.5 ampsOperating Temperature:0 to 50 DEG CLeakage current:Vibration:10-500 Hz 2G 10 min/1cycle 60 mins each along XYZ axis
Protections :

Cutoff level 140 VAC. Turn on voltage 160 VAC

300 V AC units shuts off if voltage goes above this value

Output over voltage ( Batt Charger included) - 15.5 V DC

Output short circuit and overload - continuously protected

Thermal Shutdown - protected latching mode

Battery reverse polarity - protected both on line and off line

Current drawn by charger from battery:Draws zero current from the battery under any circumstancesExternally Induced Over voltage:Protected against output overvoltage caused by parallel connection of alternator etcAnnunciation:Potential free NO /NC contact for charger On/ Fail indicationIndication:Mains On, Float, Boost, and Battery ReverseLine Regulation:Load regulation:Ripple and noise150 mv p-p
Isolation between:Input Output:2000V ACInput Earth:1500V ACOutput Earth:1500V ACDimensions:-L*B*H190*155*75mmMounting:Wall mounting typeWeight:1500gms

Product Details:

Input voltage range170-270vac / 240-385 vdc170-270vac / 240-385 vdcfrequency47 to 63 hz47 to 63 hzeffeciency85 % typical85 % typicalac inrush currentlimited to 35 amps maximumlimited to 35 amps maximumleakage currentless than 3. 5 maless than 3. 5 maoutput voltagefloat mode 26. 4 v to 26. 7vdc boost mode 28. 0v to 28. 4 vdcfloat mode 26. 4 v to 26. 7vdc boost mode 28. 0v to 28. 4 vdcoutput currentfloat mode 0 to 6 amps
boost mode 6 to 20 ampsfloat mode 0 to 6 amps
boost mode 6 to 20 ampsload regulationbetter than 23/4tter than 2%line regulationbetter than 13/4tter than 1%rippleless than 200 mv p-pless than 200 mv p-poperating temperature-20 to 55 deg c-20 to 55 deg cvibration:2. 5g from 10 to 200hzcooling:forced airhold up time:20 ms at 230vac at full loadeffeciency:around 85 %maximum rated power :560 wattsprotectionsi/p undervoltage shutdown 150vac i/p overvoltage shutdown 280 vac short curcuit and overlaod battery reverse
o/p overvoltageindicationsmains on green
float green
boost red
battery reverse redanunciationpotential free contacts for bc on/offisolationinput to earth 2kv ac input to output 3kv ac output to earth 1kv acdimensions l*b*h mm250*120*115 mmenclosurepowder coated aluminium

Product Details:

• Input under voltage - cutoff level 140 VAC. Turn on voltage 160 VAC
• Input over voltage - 325 V AC units shuts off if voltage goes above this value
• Output over voltage ( Batt Charger included) - 15.5 V DC
• Output short circuit and overload - continuously protected
• Thermal Shutdown - protected latching mode
• Battery reverse polarity - protected both on line and off line

Product Details:

Specification

• Input Voltage 150-300 V AC
• Output voltage
• Float Mode 13.4 V DC
• Boost Mode 13.9 to 14 V DC
• Inrush Current Limited by NTC Thermister
• Charging current in boost mode 10 amps
• Charging current in float mode 0 to 4 amps
• Operating Temperature 0 TO 50 DEG C
• Leakage current <2 mA at 230 vac
• Vibration 10-500 Hz 2G 10 min/1cycle 60 mins each along XYZ axis
• Protections
• Input under voltage Cutoff level 140 VAC. Turn on voltage 160 VAC
• Input over voltage 300 V AC units shuts off if voltage goes above this value
• Output over voltage (Batt charger included) 15.5 V DC
• Output short circuit and overload Continuously protected
• Battery reverse polarity Protected latching mode
• Current drawn by charger from battery Draws zero current from the battery under any circumstances
• Externally Induced Over voltage Protected against output overvoltage caused by parallel connection of alternator etc
• Annunciation Potential free NO /NC contact for charger On/ Fail indication
• Indication Mains On, Float, Boost, and Battery Reverse
• Line Regulation <1%
• Load regulation <1%
• Ripple and noise 150 mv p-p
• Isolation between Input & Output 2000V AC
• Input & Earth 1500V AC
• Output & Earth 1500V AC
• Dimensions L*B*H 170*110*85mm
• Mounting Wall mounting type
• Weight 1200 gms

With Fan / Without Fan Available

Additional Information:

• Pay Mode Terms: T/T (Bank Transfer),Other
• Delivery Time: 4-5 days

Product Details:

Specification

Input Voltage 150-300 V AC

Output voltage

Float Mode 13.4 V DC

Boost Mode 13.9 to 14 V DC

Inrush Current Limited by NTC Thermister

Charging current in boost mode 10 amps

Charging current in float mode 0 to 4 amps

Operating Temperature 0 TO 50 DEG C

Leakage current <2 mA at 230 vac

Vibration 10-500 Hz 2G 10 min/1cycle 60 mins each along XYZ axis

Protections

Input under voltage Cutoff level 140 VAC. Turn on voltage 160 VAC

Input over voltage 300 V AC units shuts off if voltage goes above this value

Output over voltage (Batt charger included) 15.5 V DC

Output short circuit and overload Continuously protected

Battery reverse polarity Protected latching mode

Current drawn by charger from battery Draws zero current from the battery under any circumstances

Externally Induced Over voltage Protected against output overvoltage caused by parallel connection of alternator etc

Annunciation Potential free NO /NC contact for charger On/ Fail indication

Indication Mains On, Float, Boost, and Battery Reverse

Line Regulation <1%

Load regulation <1%

Ripple and noise 150 mv p-p

Isolation between Input & Output 2000V AC

Input & Earth 1500V AC

Output & Earth 1500V AC

Dimensions L*B*H 170*110*85mm

Mounting Wall mounting type

Weight aprrox 450 gms

Additional Information:

• Packaging Details: At the time of courier

Product Details:

Product Details:

Automatic Battery Charger
24V 30A